Clover CDR 4170 Instruction Manual download pdf (Page 44)

7. PTZ CONTROL

1. Connect Pan/Tilt/Zoom camera’s control to RS485(+) / RS485(-) port on the rear of the system.

2. The video output of Pan/Tilt/Zoom camera to the one out of channel you wish to connect.

3. Press and hold the PTZ button for about 3 seconds on the front panel and the PAN/TILT

CONTROL screen will be displayed on the monitor.

4. Can select the order for control that user wants to do whenever ENTER button is pressed.

MOVE: Change the position of screen shown on Pan/Tilt Zoom camera.

ZOOM: Change zoom in/out value of the screen shown on Pan/Tilt Zoom camera.

FOCUS: Change focus value of the screen shown on Pan/Tilt Zoom camera.

CH SEL: Select the channel that is connect to Pan/Tilt Zoom camera.

5. After finishing setup, Press the ESC button to exit.

NOTE

• Connect only one Pan/Tilt/Zoom camera on the system.

• The protocol of P/T/Z camera should be Pelco-D Protocol.

• The baud rate of P/T/Z camera must be 2,400bps (bit per second).

ORDER

CAMERA TITLE

- 39 -

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 66 67

No comments

Clover CDR 4170 Instruction Manual Page 44